The following are examples of the most common problems and how EvoFlex can overcome them:

1.  My products are packaged when still warm, and condensation inside the wrap causes damage to the internal packaging.

Wrap immediately with EvoFlex and allow the product to cool down without slowing down the dispatch procedure.

2.  My product must be allowed to cure before being palletised. for 24-48 hours.

If this product is wrapped by EvoFlex the curing can take place without need for secondary storage.

3.  I have fully Automatic Machinery with my tension set at 225%.  I have to change gearing to use this type of film.

Using EvoFlex N1, you can replace current film without reducing your settings, thus achieving high yields and lower costs, along with full flexibility of line usage.

4.  My load is unstable and needs high levels of stretch.

EvoFlex has reinforcements, which allow for an extremely stable pallet module.  The film can be tailor made for any given application with more of less stretch left in the web.  This allows the optimisation of the finished pallet.

5.  When I wrap my pallets I have to apply so much film that the holes are covered and it is very costly.

Due to the reinforcements you only need to apply the minimum amount of film to achieve stability, this leaves holes unimpaired increasing the air flow and reducing cost and time of each wrap.

6.  I cannot get the film to cut and seal on my fully Automatic machinery.

EvoFlex can be sealed on most fully automatic lines, however if the system is such that this is difficult then we can leave 1 or 2 lanes without holes to allow sufficient film to be sealed.